|SWAP| Tein S-tech for standard Bilstein Gen 4 Liberty [NSW]
Posted: Sun Nov 26, 2017 9:58 am
Swap Soft Tein S-tech springs for your standard Bilstein GT or GT-B springs
Location Sydney, Inner West
Contact zero four double one, six double two, nine two seven
This setup is just too low for me as I carry a lot of gear, I have put 0 K's on them since purchase
The following is copied and pasted from the original owner (I purchased them on here):
"s-techs have done around 20 000 kms.
These have come off a wagon also bolt on to a sedan. My research says the rears will sit 5-6mm higher on a sedan. Please DYOR.
On a wagon this set up will sit about 45mm lower than stock std (non 3.0RB,GT-B ), 3.0RB, GT-B Tein s-techs will sit 30mm lower than stock. DYOR"
Contact me anytime
Thanks!
Location Sydney, Inner West
Contact zero four double one, six double two, nine two seven
This setup is just too low for me as I carry a lot of gear, I have put 0 K's on them since purchase
The following is copied and pasted from the original owner (I purchased them on here):
"s-techs have done around 20 000 kms.
These have come off a wagon also bolt on to a sedan. My research says the rears will sit 5-6mm higher on a sedan. Please DYOR.
On a wagon this set up will sit about 45mm lower than stock std (non 3.0RB,GT-B ), 3.0RB, GT-B Tein s-techs will sit 30mm lower than stock. DYOR"
Contact me anytime
Thanks!