Page 1 of 1
NSW - EJ25 SOHC from Gen3 lib or outback
Posted:
Wed Mar 16, 2016 8:29 pmby Rec01l
As title suggests, need an sohc ej25 in known running condition for an engine replacment im doing in a gen 3 lib, can also accept ej25 up to late my05 as ill just block off the egr.
Located nsw
Cheers,
Nath
Re: NSW - EJ25 SOHC from Gen3 lib or outback
Posted:
Wed Mar 16, 2016 9:23 pmby Surge
Where are you located?
Re: NSW - EJ25 SOHC from Gen3 lib or outback
Posted:
Thu Mar 17, 2016 7:46 amby Rec01l
Southern highlands nsw, can travel to Canberra if you have something!
Re: NSW - EJ25 SOHC from Gen3 lib or outback
Posted:
Thu Mar 17, 2016 8:01 amby BillyCorgi
Rec01l wrote:.....can also accept ej25 up to late my05 as ill just block off the egr.....
To fit an early Gen4 into a Gen 3, you also need to change the timing belt pulley on the crankshaft, as the timing marks on the pulley are different.
Re: NSW - EJ25 SOHC from Gen3 lib or outback
Posted:
Thu Mar 17, 2016 5:49 pmby Surge
If happy with the above change required, then I'll see if what I have would work for you.
I have a gen 4 liberty that had a front drivers corner impact. I'll see if it has oil and try and start it this Sunday.
Depending on how it runs I should be able to get more details for you (km on it ).
Since Ive bought the car I haven't tried to start it.
Payed $500 for it so I wouldn't ask much for the engine.
I'll send you a PM if it runs ok when I have a chance to check.