club.liberty.asn.au

hey guys, after a left and right front inner plastic guards to suit 2006 MY07 spec B liberty wagon, or if anyone knows a good subaru wrecker in the Bankstown/sydney area, cheers

Jump on gumtree or eBay mate. There are plenty of wreckers in your vicinity. Also all inner guard plastics are the same thoughout the gen 4 range so they aren't model specific.

Mat04 wrote:Also all inner guard plastics are the same thoughout the gen 4 range so they aren't model specific.

Not correct.

04-06 2.0i, 2.5i, GT and 3.0 are the same.

07-09 2.5i, GT, GT-b and 3.0-b are the same but different from the pre-facelift models.

Pretty sure Outback is different again from Liberty.

dave wrote:hey guys, after a left and right front inner plastic guards to suit 2006 MY07 spec B liberty wagon, or if anyone knows a good subaru wrecker in the Bankstown/sydney area, cheers

Interested to know how much you end up paying for one.
I've need the front right for a while (missing the front lower half) and its exposing the fog light housing to water and dirt.
They're $150 from Japan Parts. Been too lazy to check Subaru parts here.

cruisn wrote:

Mat04 wrote:Also all inner guard plastics are the same thoughout the gen 4 range so they aren't model specific.

Not correct.

04-06 2.0i, 2.5i, GT and 3.0 are the same.

07-09 2.5i, GT, GT-b and 3.0-b are the same but different from the pre-facelift models.

Pretty sure Outback is different again from Liberty.

That's strange... I have my07 gtb sedan inner guards on my my04 outback. All clips went into a hole.

Mat04 wrote:
That's strange... I have my07 gtb sedan inner guards on my my04 outback. All clips went into a hole.

The front half of each is slightly different, but if they all fit, then hey!

I was unsure about Outback, never tried one. They must be the same as '07-09 due to the wider front bar.

Other pre face models are different. Ive done the swaps.

Part number for the front-drivers side splash guard for a pre-fl 3.0?
Why isn't there a website for part numbers...