Page 1 of 1

In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sat Nov 05, 2016 1:25 pm
by Shrab Kebab
Hi,
I Have a gen3 2000 liberty rx my00 (Pre Facelift)
Im in need for some mod ideas, It's pretty much stock
Anything Helps
Thanks Alot
Shrab

Re: In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sat Nov 05, 2016 7:19 pm
by Surge
It's probably worth more being stock.

But wheels and tyres might be a nice start.
Maybe some brakes from a gt liberty or wrx 4 pots.
New brake fluid.

If it's manual, short shifter and good bushings to keep the gearbox feeling nice.

Sway bars and coilovers.

Look at improving handling and braking. Can't do much for power.
Unless you can find a wrecked wrx or similar to get a drivetrain swap.

Re: In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sun Nov 06, 2016 7:27 am
by Shrab Kebab
Thanks alot,
And no unfortunately it's an auto
Do you have any wheel size Reccomendations?

Re: In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sun Nov 06, 2016 7:37 am
by Surge
I'd go with the 2011-2014 WRX stock wheels.
Size: 17x8"
Offset: +53
Bolt pattern: 5x100
Weight: 21 lbs
OEM-equipped tire size: 235/45R17
Notes: Clears four-pots

Image

Re: In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sun Nov 06, 2016 10:56 am
by Shrab Kebab
And If I went for these 18'x7' wheels would i have to roll the guards in, also what do you think an appropriate offset would be?
If Not what do you think about painting the stock wheels black and brake calipers red and chuck on some new springs and lower the car a bit

Re: In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sun Nov 06, 2016 1:33 pm
by Surge
Your plan sounds like a good idea.

If you change wheels stick to an offset of +50 to +55.
Otherwise you may need to roll the guards.

Coilovers can be had pretty chesp second hand, they would give you a better chance to get the best height.

Re: In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sun Nov 06, 2016 3:36 pm
by Surge
Depending on the colour of your car, this stuff could look good:

http://www.subyclub.com/topic/12591-199 ... ntry608037

Re: In Need For Mod Ideas For Gen3 Liberty

PostPosted: Sun Nov 06, 2016 10:00 pm
by Shrab Kebab
Hmm ok thanks I'll take coilovers in mind
I don't think the hood would work because if it's from a b4 it doesn't fit on the gen3 because I have a pre facelift, the front end of the b4 is the same as the post facelift