Page 1 of 1

B4 Suspension redo

PostPosted: Tue Oct 04, 2016 3:20 pm
by BBB4
Hi there,

I've recently had a new anti-lift kit and rear shocks installed by Pedders Heidelberg.
Let's just say the car has been there 3 times and still knocks front and rear passenger side, which doesn't bother them.
So I'm wondering if there's a suspension mob/guy you can recommend who might be more practiced with Subaru's.
It's an 02 Liberty B4, hoping the parts just need to be reinstalled properly.

Thanks a lot.

Re: B4 Suspension redo

PostPosted: Thu Oct 06, 2016 12:49 pm
by craig_
Hey mate,

Where are you located? Its not in your bio.
I have a third gen and it clunks (only when cold) and turning left. Yeah, go figure. In my case, I can't see any busted bushings, and since the noise is a constant DONK DONK DONK, i am now assuming its a wheel bearing or a drive shaft. I'll wait until it gets worse.

Check out http://opposedforces.com/parts/legacy/e ... tration_1/ and pay particular attention to part #25.
Get under the car with a torch and have a look at each bush to see if it's split etc.

How many kilometers and what other mods do you have? Can you describe the clunking?

Re: B4 Suspension redo

PostPosted: Thu Oct 06, 2016 4:11 pm
by BBB4
G'day,

I'm in Heidelberg, so North East but metro is fine.
Mine clunks under load (i.e. driveways and dips/undulations in the road), I hope yours isn't the drive shaft!

Had an engineer in the car who picked both parts out straight away when I asked him but I'll check out the bushes.

It's done almost 145k, as far as mods bugger all except the new anti lift and rear shocks.

Re: B4 Suspension redo

PostPosted: Tue Jan 03, 2017 11:05 am
by et2428
How has the anti lift kit performed? It is supposed to stop the nose from lifting when accelerating right?