Page 1 of 1

2002 Liberty B4 auto to manual now with wiring info

PostPosted: Sun Feb 18, 2018 9:28 pm
by sintx3
Hi everyone one i have a 2002 liberty b4 twin turbo that is currently auto and i am wanting to change it to manual. So far i have all the things i think i need, i am just trying to find out any other information i need to do this like wiring and any misc bits i may have missed. I have done a fair bit of searching on the web about converting to manual but most of the info i have found is for the 2nd gen liberty/legacy so need more 3rd gen specific details if anybody had any info that would be greatly appreciated.



So far i have the following



Manual trans

tailshaft

diff

manual ecu

clutch and brake pedals

shifter assembly

clutch slave and master cylinders

manual starter motor

And i know i have to wire up the neutral sensor and reverse lights.

Re: 2002 Liberty B4 auto to manual conversion need info plea

PostPosted: Wed Mar 14, 2018 11:50 am
by sintx3
I am about to start my manual conversion in the next coming weeks ill post up a thread about how i went and any problems i had for anyone that had an interest in doing the same thing to their gen3.

Re: 2002 Liberty B4 auto to manual conversion need info plea

PostPosted: Fri Jun 15, 2018 5:37 pm
by sintx3
All done and working well except an ABS light here is some idea of the wiring i did

Hi guys got it all written up sorry its only hand written. Now just to give you an idea plugs B128 and B17 are on your new manual trans, B12 is one of the plugs that goes from the firewall to the auto trans and B54 & B56 plug into the auto trans computer under the dash where you will be putting the clutch pedal.

Be5 rev D auto to man small.jpg
Be5 rev D auto to man small.jpg (246.67 KiB) Viewed 731 times