Page 1 of 1

Need model B4 Base Ingition Map

PostPosted: Wed Jul 13, 2011 9:39 pm
by scooby_001
Hi guys,

Ive been searching for days and days with no luck and hoping someone here can help me out. Ive got an MY98 WRX and ive dropped a Liberty B4 powerplant in it and have switched it to a single turbo setup. Ive also upgraded the ECU to a PowerFC but its a EJ20K PowerFC with the base map for a EJ20K. What im after is the base map for any model of Liberty B4 which i can start with and use to tune my ECU as the EJ20K base map is completely different due to the difference in compression. Is anybody out there able to help me? Any ignition map in any state would be awesome as i just need it as a starting point from which i can start tuning. I have already tuned my fuel and my AFRs are spot on, now its ignition time...

I have attached my current ignition map so you can see just how far off the current one is.

Thanks in advance
Rich

Re: Need model B4 Base Ingition Map

PostPosted: Fri Jul 15, 2011 6:06 pm
by scooby_001
Please help guys... Im so desperate ill Paypal $20 across to the first person who can send me an untouched base ignition map for a Legacy B4 2.0 EJ20 TT as its delivered from the factory - any takers?

Re: Need model B4 Base Ingition Map

PostPosted: Sat Jul 16, 2011 12:10 am
by telemekas
If you can you use RomRaider/Enginuity? Their is a freely available JDM TT map with its XML available.

Re: Need model B4 Base Ingition Map

PostPosted: Sat Jul 16, 2011 9:27 am
by scooby_001
Hi telemekas,

Thanks for getting back to me mate. I dont have the dongle used with RomRaider but i downloaded it anyway earlier this week. I go hold of heaps of B4 users HEXs and installed every XML definition for B4s that i could, but every ROM i tried to open said there were no definitions loaded for it? nothing wants to work :( Is there something im doing wrong?

Thanks
Rich

Re: Need model B4 Base Ingition Map

PostPosted: Sat Jul 16, 2011 1:19 pm
by telemekas
What size are the XML definitions that you have for the TT?.
The TT XML should be 176KB .

Re: Need model B4 Base Ingition Map

PostPosted: Sat Jul 16, 2011 9:40 pm
by scooby_001
hi mate,

I finally managed to get the definition file but now its looking like every Standard ECU ROM only holds a few basic parts? Ive attached a screenshot

Ive also found the following thread which says the definitions for the B4 only have the DTS, not the tuning part?

http://romraider.com/forum/viewtopic.ph ... 55&start=0

Does this sound about right? if so i guess what im looking for doesn't actually exist...

Thanks
Richard

Re: Need model B4 Base Ingition Map

PostPosted: Sun Jul 17, 2011 12:37 am
by telemekas
pm sent