club.liberty.asn.au

Can anyone please help, I just bought a fascia set for my car and i need to know if i HAVE to wire it in or is there someone in Melbourne that sells the wiring harness, if so where are they and how much money would i be looking at?

Thanks!

What's in the kit?
My understanding is that you buy the kit to suit your hvac controls so that part should be plug n play.
Then find a way to interface your new head unit with eg the stock amp which is usually via a 13 pin din plug.
I'll dig up some reference material

http://forums.nasioc.com/forums/showthr ... stcount=11
See installs links I'd say

My08 double din install:
viewtopic.php?f=22&t=7702

Yea the fascia kit is just a simple plug and play but uses your original hazard button.

Assuming the 2.5i only ever came with the kenwood system you'd be simply looking at finding the correct adaptor to go from your new headunits output to the standard subaru speaker wiring harness, or just cut the new one in using the new headunits provided one sided harness.
Here's the subaru wiring colour chart if you end up going with a homemade job.
http://ae64.com/Legacy-pinout.htm

Didn't think the kenwood systems were amped benny?

andy_mac wrote:Yea the fascia kit is just a simple plug and play but uses your original hazard button.

Assuming the 2.5i only ever came with the kenwood system you'd be simply looking at finding the correct adaptor to go from your new headunits output to the standard subaru speaker wiring harness, or just cut the new one in using the new headunits provided one sided harness.
Here's the subaru wiring colour chart if you end up going with a homemade job.
http://ae64.com/Legacy-pinout.htm

Didn't think the kenwood systems were amped benny?

thanks for your help guys.

and fyi the kenwoods aren't amp'd

any idea who i could speak to????, i have no experience with wiring at all!

Good point!
Why not buy a ready made harness via the link in the link?
http://ae64.com/WRXharness.htm

Since you probably live in Melbourne pm mihai for install help

bigBADbenny wrote:Good point!
Why not buy a ready made harness via the link in the link?
http://ae64.com/WRXharness.htm

Since you probably live in Melbourne pm mihai for install help

I went into auto barn and they told me that the harness from the factory to an aftermarket head unit doesn't even exist -
Ive yet to hear from Mihai. gonna go have a bit of peak at the legacy forum! wich me luck!

Well thats a massive yarn. Depending on what your headunit comes with you may need two adaptors.
Here's an example for a pioneer headunit. Its a nz site but gives you the right idea.

Subaru harness > iso harness
http://www.abtec.co.nz/Ed_s_W_NO537E

Iso harness > pioneer harness
http://www.abtec.co.nz/Ed_s_W_NO534PI2

I picked up a harness from Supacheap for under $15.
They have a whole selection dedicated to harnesses.