I bought this a few months back, but just haven't found the time to install it yet. So I finally made a promise to get it installed over the long Easter weekend.
I don't know about other people, but I like to rest my rest on the shift knob while I drive. However Subaru made the centre console a bit far from the shift knob so I can't rest my elbow on it at the same time. A bit annoying since most other cars I've been in have a sliding arm rest. So this was much welcomed in bridging that gap.
The Corazon slider took about an hour to do, and requires a bit of drilling into the current arm rest to fit the rails. It sits about 30mm higher and slides about 80mm (you can remove the stopper so it slides even further). I tried to fit it along with the Subaru dual console, but the arm rest sat a bit too high with both. So I had to give up the dual console.
The arm rest, un-extended
The arm rest, extended. Note how it covers up the rear cup holder
Another view of the extended arm rest
A view of the console from the back. I'm not keen how it doesn't cover up everthing, leaving the hinges exposed.