club.liberty.asn.au

...following on from the recent post by Arith (link below)

http://forum.liberty.asn.au/viewtopic.php?t=2970

i recently noticed these have popped up on japanparts.com for the early model gt libs from a company called burnout.



after seeing how good similar fenders look on a tb sti spec b i must admit im kinda tempted to try out these.

at the end of the day the question is, are they worth the trouble of ordering, importing and painting / fitting?

thoughts?

I like them.

jim...... where a you???

mate check the mods section their is similar vent you can add to your exisitng fenders, just need to cut and fold them.

See Arith's car, good example.

i have a set of these in my garage which iv been deciding weather to fit for the last 3 weeks now (still undecided)

at a tad under 880 a guard (yes thats each) i would'nt buy another set

I also saw these as well. But they are only for the A~C series (MY04-MY06) and they had 2 vents rather than 1. That's why I needed Phat to custom order mine.

senator wrote:check the mods section their is similar vent you can add to your exisitng fenders, just need to cut and fold them.

Where is this? If I had known that I wouldn't have gone through the trouble of mine!

At the end of the day it's a matter of why you're modifying your Lib to begin with. These do not add any power nor do they dramatically effect appearance. However the uniqueness factor is high. For me I just wanted to try something different (I'm sure others may have tried and if they have I haven't heard or seen them yet).

i'll take them off ur hands phat!!! hahaha 2 for the price of 1 right!?!?! haha

LIBIDO wrote:i'll take them off ur hands phat!!! hahaha 2 for the price of 1 right!?!?! haha

GO SSSSSSSSSSSSSSSSSSSSSSSSSSSSUPASTAAAAAAAAAAAAAR!!!!!!

Is it flared as well as vented?

If not flared, you can get a panelbeater to vent it, and bog with fibreglass + mesh. I've seen my panelbeater do it on bonnets and fenders before.