club.liberty.asn.au

So I'm looking into a diffuser for the rear end...

I'm running 2.5" quad tips and I have melted some of the plastic around the muffler tip cut outs.

I'm wondering if carbon fibre will have a better chance of standing up to the heat of the muffler tips compared to plastic?

Thoughts?

The plastic will most likely be PP which melts at 130 degrees, carbon fibre resin should resist the heat considerably better

Thanks .
I will be a little upset if i end up melting my nice new CF diffuser.

All depends on what resin is used. Heatproof one might be ok but the diffuser will more than likely get closer to the exhaust than your stock diffuser.

hamish_023 wrote:All depends on what resin is used. Heatproof one might be ok but the diffuser will more than likely get closer to the exhaust than your stock diffuser.

Thanks Hamish . Ill have to ask.

Ill report back.