club.liberty.asn.au

I got a Corazon grill so am doing another mesh grill albeit better than the first one I did.

Leaving the grill full depth and after cutting out the inside have a few holes to fill. The indent in the lower section is also getting filled to make it level.

Proper plastic hex mesh sourced and should come up a treat in the end.

you want a prototype 3RB grill to work on?
i want the wings gone, mesh in the back but keep the polished surround...

Robbks wrote:you want a prototype 3RB grill to work on?
i want the wings gone, mesh in the back but keep the polished surround...

Already done one of those before.

Should turn out awesome, Mark. Looking forward to seeing the finished product.

cruisn wrote:

Robbks wrote:you want a prototype 3RB grill to work on?
i want the wings gone, mesh in the back but keep the polished surround...

Already done one of those before.

but you need the practice....
i've got one you can practice on..

If you dont mind me asking where did you get the mesh from?

lunchboxsti wrote:If you dont mind me asking where did you get the mesh from?

+1

Keen to see finished product on a car.

I have a 100% stock grill sitting in my garage

The mesh wasn't cheap, I'll say that much. I'm going to feel bad if you come out with a loss here, Mark. Also interested where you got it though.

Mesh was sourced from Sydney Special Vehicles via Ebay....

http://www.ebay.com.au/itm/110857971807 ... 2373wt_952

The cost isnt too bad now Rosey as Hamish is taking half.

cruisn wrote:Mesh was sourced from Sydney Special Vehicles via Ebay....

http://www.ebay.com.au/itm/110857971807 ... 2373wt_952

The cost isnt too bad now Rosey as Hamish is taking half.

Cheers for that. I don't feel as bad now.

Getting closer to completion......

Side gaps filled, smoothed and finished.



Ive done about 7 layers of filler in the centre divet to keep any shrinkage to a minimum allowing 24 hours+ between layers. Sanded back and level.



I paint over the area black as it shows any low points. Its all good. Now sand it back with 400 grit ready for under coat.



Mesh cut to size and badge.

Good work man this looks neat!

Looking forward to it on the car!

I received my 1/2 of the honeycomb, thanks Mark

NICE. when i first got my gt I was considering a Front end Pre/Post face swap... only cause I wanted a honeychomb grille lol. Looks great Mark *thumbs up*.

Hamish: you doing yours with the honeychomb behind the grill or more at the front like the factory ones?