Apologies if this has been discussed before as I did a search but could not find.
Recently purchase the chrome covers for the headlight washers.
Then I learnt there are more parts needed such as steel brackets:
Part No: 86644G000 (RH)
Part No: 86644G010 (LH)
I could fabricate these if I had a sample.
Then a plastic component that clips in between the chrome cover and end of the washer port. (no separate part number.)
Has anyone considered 3D printing this plastic part? Should be quite some demand for it and sell on the forum?
If anyone has these parts could you please reply as I can't find them on any part supply including 'partsouq'
Thanks!