club.liberty.asn.au

Hi, has anyone tried to fit Hella horns to a 2008 N/A Liberty or know if they fit at all

Thanks

Yes I have fitted hellas to my GT.. Na shouldn't be any different. I have an Sti grill and it just pops out when the 3-4 clips at the top are pressed in.. My car is Grey metalic with very little colour so I have done the calipers in Yellow and bought Yellow Hella High tones to match.. depends on light conditions whether they are easy to see or not...All I did was made a bar that bolts onto the upright support in the middle of the grill and put a horn bolted to either end. I left 1 of the 2 factory coil horns attached and used the loom to the other stock horn as the "switch" for the relay.. Pretty easy install..We have them on the GC8 Sti and the GC8 CSE2 and it is a much tighter fit.. There is vary little room and you only have 5mm gap on one side of each. At least eh Libertys have a lot of room in there..

Thanks man, Just ordered a new grill and a set of Hella’s!

Make sure your brake calipers match your horns!

Mission success!

That looks good. I have the red supertones on my GC8 rex. You may want to reduce pics to 1800 x whatever so it fits on the screen without having to scroll around to see things.. Did you buy the grill or make it..It looks like the mesh I used to make a stone protector for the rear aircon condenser on my 4x4. It's easy stuff to work with and allows great airflow..

Purchased Grill from Ultrex Performance