club.liberty.asn.au

I noticed this unplugged connector in the LH (Passenger) Footwell area.

Any ideas what it is for?

It's a single wire, and goes into the big cable harness seen in the picture.

I recently had a service, but I rarely pull up the carpets so it could've been undone for years. I don't have any warning lights or anything not working as far as I know.

Test mode connectors - only plugged when diagnosing ecu / canbus / sensor related failures on the post facelift

For the prefacelift, these need to be connected when flashing tunes / roms into the ecu

Mick

OK thank you Mick!

So for my post FL model I'll leave it disconnected.

tom_kauf wrote:OK thank you Mick!

So for my post FL model I'll leave it disconnected.

Yep