Page 1 of 1
HKS SSQV
Posted:
Tue Mar 04, 2008 5:53 pmby tangcla
For those who have got an SSQV on their Liberties:
Did you use the model-specific kit?
Did the engine cover have to be cut?
Do you have pics of the bov install?
Posted:
Tue Mar 04, 2008 6:55 pmby LIBIDO
this is the only pic i have mate.
It wasn't the model specific kit....dremeled only a small fraction of the optimus prime cover.
Posted:
Tue Mar 04, 2008 8:38 pmby Arith
GFB was theo only brand I came across that has an application specific BOV that doesn't require mods or cutting.
Everything seems to be universal and will require some sort of cut on the engine cover.
Posted:
Tue Mar 04, 2008 8:56 pmby tangcla
I have the GFB Hybrid GT at the moment... was just wondering, that's all.
Posted:
Tue Mar 04, 2008 11:16 pmby Arith
I do too. They are quite different in the sounds they produce (GFB and HKS). Were you looking to change to the whistle?
I think GFB has an adapter that you can fit in place of the trumpet to make it whistle similar to the SSQV's.
Posted:
Wed Mar 05, 2008 7:19 amby tangcla
Contemplating the whistle, but rrp is $39 and there's not that much of a markup on them...
Should run my bov back in atmo again. Or, just do what I am thinking of doing and going back to a near-silent setup (panel filter, plumback BOV) and just hear the sound of turbo spool
Posted:
Wed Mar 05, 2008 1:59 pmby bonski
My understanding (and I dont know the reasoning behind it) is that you cannot fit the whistle to the Liberty GT (GFB model)
Posted:
Wed Mar 05, 2008 2:02 pmby tangcla
Maybe due to the flange bolt being quite close to the trumpet, perhaps? *shrug* just guessing. cos I found I had to remove the trumpet before I could fit/remove the BOV.
Posted:
Thu Mar 06, 2008 9:58 pmby Akwoo
u might have issues running atmo.
alex's car started having issues when it ran atmo then we had to change it back to plumb back.
Posted:
Thu Mar 06, 2008 10:29 pmby tangcla
icandy wrote:u might have issues running atmo.
alex's car started having issues when it ran atmo then we had to change it back to plumb back.
What sort of issues? Mine seems to be running fine in atmo...
Posted:
Thu Mar 06, 2008 10:37 pmby Akwoo
engine idling all over the place, pulse racing had to plumb it back in the end.
but then again he's running to avo450L turbo, so don't think u have to worry too much until we chuck a bigger turbo on your car.
Posted:
Fri Mar 07, 2008 6:48 amby tangcla
I have rough idle issues, but that was before the bov was atmo. Tried plumbing it back but that didn't make a difference. Might be due to the downpipe.
It's running in 50/50 atm