Best place to pull wiring through engine bay?

[tangcla]

So I got my boost gauge - looking to pull the wiring through into the cabin.

Where's the best place to pull it through?

[Arith]

I know where you can pull it through.

[tangcla]

I know where you can pull it through.

not that sort of pulling dude

[SkoobyGT]

Just above your brake pedal there is a grommet.

Have a look from the engine side where the cables go in.

Push it in...yes....all the way in so it comes out the other side.....then...pull it out. (Cmon I am talking about the cable)

Takes literally 40 seconds to do.

[tangcla]

Thanks Mick. I got a boost gauge and an EGT gauge to pull through... at some point... when I can be bothered.

I need some 4mm hose though. Stingy Defi only supply 0.5m, that's not enough for anything!

[GTSPECB STI]

yep stingy is right! I am in the same boat but waiting on another defi gauge before I install them in the cubby pod.

[tangcla]

Have you got the cubbypod yet?

[Mo_GT]

You can also use the factory point (where the ecu cables go thru), there's enough room there for 0g cable - this is where all my cables go thru.

Its located just under the passenger strut tower.

[GTSPECB STI]

Have you got the cubbypod yet?

yes pod arrived last week, just waiting on another gauge from Troy at Prospeed to arrive then I will do the install. Pic on last post here
http://forum.liberty.asn.au/viewtopic.p ... 9&start=30

[Bumpty]

Could also go through the aircon grommet on the passenger side of the firewall, look for it from the engine bay...

[tangcla]

I found the spare grommet next to the brake master cylinder I poked it in through there.

[Bumpty]

Wow, the sexual innuendo just keeps, coming (oh... and there I go)