club.liberty.asn.au

Posted: **Fri Apr 09, 2010 4:09 pm**

Hi all
Just took apart one of my Brembo calipers to examine the pads before i put them on the car and noticed that they had pitting on them.Now i know that's not normal so are the still good to use as they should wear down or will they stuff up the rotor, or should i

replace them here's a few shoots, one set is better than the other :cry:

PS Rear's look OK I think

Rotor's look good too, no marks on them.

Posted: **Fri Apr 09, 2010 5:04 pm**

Looks like they've been overheated at some stage and bits started crumbling off. I'd use em for everyday but probably not for motorsports.

Posted: **Fri Apr 09, 2010 5:11 pm**

Least you know what your pads are... mine are blue with no other markings on it, and I know they're not Project Mu or A'PEXi Blue pads

Posted: **Fri Apr 09, 2010 5:20 pm**

i wouldnt use them as they are harsh on the rotors anyway..get yourself some dixcels of phat

Posted: **Fri Apr 09, 2010 5:21 pm**

teK-- wrote:Looks like they've been overheated at some stage and bits started crumbling off. I'd use em for everyday but probably not for motorsports.

Do you think that they will f...... up the rotor :?:

or over a little time they will flaten out

Posted: **Fri Apr 09, 2010 5:23 pm**

Lib 3.0LR wrote:
teK-- wrote:Looks like they've been overheated at some stage and bits started crumbling off. I'd use em for everyday but probably not for motorsports.

Do you think that they will f...... up the rotor or over a little time they will flaten out

brembo pads waer out rotors from new..why use them they look like crap

Posted: **Fri Apr 09, 2010 5:30 pm**

jdm rsk wrote:
Lib 3.0LR wrote:
teK-- wrote:Looks like they've been overheated at some stage and bits started crumbling off. I'd use em for everyday but probably not for motorsports.

Do you think that they will f...... up the rotor or over a little time they will flaten out

brembo pads waer out rotors from new..why use them they look like crap

You do have a point :wink:

Posted: **Fri Apr 09, 2010 5:42 pm**

Well can any one out there give me rotor thickness on the standard Brembo's
My Front's are 29.7 mm
Rear's are 20.2 mm
Is this acceptable :?:

Posted: **Fri Apr 09, 2010 8:53 pm**

Lib 3.0LR wrote:Well can any one out there give me rotor thickness on the standard Brembo's
My Front's are 29.7 mm
Rear's are 20.2 mm
Is this acceptable

your rotors a brand new ....... front should be 30mm and rear 20mm when new

but your pads are screwed, they will fall apart very quick in that condition,

IMO they are mositre affected

I think phat still has a special on dixcel pads ....................