Page 1 of 1
Scrubbing inside edge of rear tyre 3.6 Liberty
Posted:
Tue Jan 10, 2017 4:49 pmby Russelll
Having issues with tyre scrubbing on the inside edge of both front and rear tyres. I have had wheel alignment done with pins to correct alignment. Is there something else to look at as tyres are still wearing on the inside. Thanks in advance
Re: Scrubbing inside edge of rear tyre 3.6 Liberty
Posted:
Tue Jan 10, 2017 5:00 pmby BillyCorgi
There is no adjustement for camber on the rear of a Gen5
Factory camber should be -1 degree with 18 inch wheels
This is what the Fcatory Service Manula says regarding adjustment
NOTE:
• Front and rear toe-in and front camber can be
adjusted. Adjust if the toe-in or camber tolerance
exceeds specifications.
• For other items indicated in the specifications table,
there is no adjustment mechanism. If other
items exceed specifications, check the suspension
parts and connections for deformation, and replace
the parts if defective.
Re: Scrubbing inside edge of rear tyre 3.6 Liberty
Posted:
Tue Jan 10, 2017 5:06 pmby Russelll
The camber is greater than 1deg. It is visible to the naked eye. Can someone suggest a good location to have this seen to in the Caboolture/North Brisbane area.
thanks