Page 1 of 1

RAYS VERSUS TURISMO

PostPosted: Sun Jun 02, 2013 10:48 am
by Jim2013
Anyone had experience with this brand?
Just seen a set that I think would look good on my silver 04 for $650 - new.
I know the standard mags are 55 offset does 48 cause any issue? Yes I am a novice!!

17x7+48 5/100 Silver RAYS VERSUS TURISMO SPADA

Re: RAYS VERSUS TURISMO

PostPosted: Sun Jun 02, 2013 11:03 am
by paggaz
Haven't had experience with that brand, but those specs should fit perfectly. The difference will be the rim 7mm closer to the outer guard.

Re: RAYS VERSUS TURISMO

PostPosted: Sun Jun 02, 2013 4:48 pm
by Boostaddict
They are Rays.... They are wicked. Those in 19's would look sick.!!'

Re: RAYS VERSUS TURISMO

PostPosted: Sun Jun 02, 2013 6:16 pm
by Jim2013
Just asked a mate to do a quick mock up for me of two sets I like..
Needs a bit of low....Was not going down the coilover path but I think if I want it spot on, height wise, I'm gonna need to...
Was gonna get a tint but I kinda like it without...
Comments welocme...
Jim.

Re: RAYS VERSUS TURISMO

PostPosted: Sun Jun 02, 2013 9:07 pm
by Boostaddict
The problem is that the original wheels are only 17's and would look a bit shit IMO .

You can get the BBS LM's in a copy in 18-20", so they are more true in the photoshop pic.!!

Re: RAYS VERSUS TURISMO

PostPosted: Mon Jun 03, 2013 8:29 am
by Manaz
Jim2013 wrote:Needs a bit of low....Was not going down the coilover path but I think if I want it spot on, height wise, I'm gonna need to...


Going low isn't a reason to go coilovers - you can get plenty low with lowering springs (and dampers to suit).

Re: RAYS VERSUS TURISMO

PostPosted: Mon Jun 03, 2013 12:24 pm
by Jim2013
Manaz wrote:
Jim2013 wrote:Needs a bit of low....Was not going down the coilover path but I think if I want it spot on, height wise, I'm gonna need to...


Going low isn't a reason to go coilovers - you can get plenty low with lowering springs (and dampers to suit).


Thanks for the info...I'm only looking for a very small drop 20mm - 30mm, not slammed, and did not want to end up too low on lowering springs.

Cheers - Jim.