club.liberty.asn.au

Hi guys

Iv done a brembo conversion on a 08 GTB and going to fit new rear discs (with handbrake shoe of 190mm) and the gtbs are 170mm..

So what can I do here?? Insert a sleeve to reduce the 190mm to 170mm or get new shoes??

Any ideas and where do I get them from??

You can get the stock handbrake shoes refaced by a business in Sydney.

The info is on this site somewhere: http://tinyurl.com/lvf9zmc

Pretty sure crusin did this.

As above, reface linings using thicker friction material.

and Hyrax, but I cant find where they got it done... PM?

I swear I saw a post the other day where Mark mentioned a company that'll put an extra 10mm pad on... Can't find the post tho

zch91 wrote:I swear I saw a post the other day where Mark mentioned a company that'll put an extra 10mm pad on... Can't find the post tho

Marion Brake & Clutch at Belmore

So just for googles sake...

If you want to modify liberty gen 4 170mm handbrake shoes for 190mm wrx sti rear discs for Brembos as suggested by Hyrax and Cruisn one should take the handbrake shoes to Marion Brake & Clutch at Belmore Sydney NSW .

This is very sticky worthy !

alessandro132 wrote:

zch91 wrote:I swear I saw a post the other day where Mark mentioned a company that'll put an extra 10mm pad on... Can't find the post tho

Marion Brake & Clutch at Belmore

I've also seen companies selling sleeves that fit inside the 190mm discs to reduce them for conversions. Godspeed brakes is one of them that does this. But they're UK based.

bigBADbenny wrote: one should take the handbrake shoes to Marion Brake & Clutch at Belmore Sydney NSW .

Hahaha.....
I was thinking the same.

For Melbourne folk, you could try here http://betterbrakesmitcham.com.au/, ask for Stuart.