Some of you may know, i recently upgraded to GT 18inch wheels and wrapped some Pirelli Pzero rubbers around them.
Previous rims and tyres: OEM 17 inch wheels, 225/50/17 Yokohama A10
New rims and tyres: OEM 18 inch GT wheels, 225/40/18 Pirelli PZero
Just had them installed on to the car today and Payless tyres, mounted on to the rim, wheel balance and installation. Drove the car out of the Payless, felt a bit wobbly. But a few minutes of driving on my usual route to work it stopped feeling wobbly, i guess they broke in.
I could immediately feel the differences on the roads i take to work, compared to the stock Yokohama A10s that are on the 17s. Cornering is much flatter and the car didn't lean through corners as much as it did on the Yokohamas (im guessing this is due to the smaller sidewall on the 18s) and less road noise and no squealing through corners at mid pace. Got to test the grip thoroughly on these tyres because some moron didn't indicate out of a round-a-bout, slammed the brakes at about 30-40km/h, no squeal, stopped on a dime.
Pros:
- Relatively good grip
- Lower profile, less sidewall flex (less "swaying" through corners)
- Cheap (if you look around)
Cons:
- Smaller circumference than stock (Speedometer error by 3%, not much.. i guess)
- Expensive, if bought at retail
- If kept in the car, leave a nasty rubbery smell lingering in your car haha
Here's where i got them from, if anyone's interested.
http://www.ebay.com.au/itm/PIRELLI-225- ... 3a7d60dc22

