Apexi intake manual

by **overl0ad** » Fri Nov 14, 2008 9:47 am

hello, does any1 have the orginal install manual?

i bought ben's old one and just want to make sure that i've got it installed right.

thanks heaps.

by **Arith** » Fri Nov 14, 2008 12:44 pm

Just make sure the pod filter is on the INSIDE of the engine bay.

by **gillottine** » Fri Nov 14, 2008 12:52 pm

I've just done one myself with no manual, it's pretty easy. You use all the same mounting points as the original filter box including the heat sheild behind the headlight

If you get stuck shoot me a PM

by **overl0ad** » Fri Nov 14, 2008 1:11 pm

ben gave me 2 brackets, i've only used one and it feels like it's on good. just wondering if i need the other one.

also the likee funnel plate thingy, it's required yeah? cos the car chucked a CEL 24 hrs after i put the finter in.

by **gillottine** » Fri Nov 14, 2008 1:30 pm

yeah I had two brackets with mine, only used the one and it's fine.

What's the funnel plate thingy :?:

by **overl0ad** » Fri Nov 14, 2008 1:32 pm

it's a silver plate that seem to help channel the air onto the air sensor.

sits between the actual filter and the intake alloy pipe.

by **ultrablue** » Fri Nov 14, 2008 1:46 pm

mine has the funnel and had no problems

by **Arith** » Fri Nov 14, 2008 1:47 pm

I think the Blitz kit came with that as well. Phat told me not to use that unless I was getting the CEL which comes up because the air flow sensor readings are off. I think you should try it without that plate/bar.

by **bonski** » Fri Nov 14, 2008 2:42 pm

If I worked it out sans manual

Surely you can...

I only posted this to get in front of Chriskan who will undoubtedly make some joke to this effect.

by **overl0ad** » Fri Nov 14, 2008 2:46 pm

i cleared the CEL this morning (one of the boys has an OBDII scanner), but i'll keep an eye on it.

by **sarbarooliberty** » Fri Feb 06, 2009 5:58 pm

Quick question about the Power Intake...

Does it void the warranty on the car if installed?? and also are there any issues installing the unit??
Looking at putting one on a 07GTB which is still under warranty.

Cheers

by **Mano™** » Sat Feb 07, 2009 11:25 am

I have both brackets on.. put them on cause the holes where there for it lol! as for the silver bit, cannot remember if I put that on or not..

by **overl0ad** » Sat Feb 07, 2009 8:23 pm

sarbarooliberty wrote:Quick question about the Power Intake...

Does it void the warranty on the car if installed?? and also are there any issues installing the unit??
Looking at putting one on a 07GTB which is still under warranty.

Cheers

i honestly don't know.

by **Resonate** » Sat Feb 07, 2009 9:37 pm

sarbarooliberty wrote:Quick question about the Power Intake...

Does it void the warranty on the car if installed?? and also are there any issues installing the unit??
Looking at putting one on a 07GTB which is still under warranty.

Cheers

I'm pretty sure that if you end up with any problems and take it back to subaru, they will do whatever is in their power to place the blame on the aftermarket part therefore effectively rendering your warrenty void.

Also off the subaru website:

Repair, replacement and adjustment under the Subaru new vehicle warranty are not available for deterioration, defects, faults or failures due to:

Modifications or alterations, which have not been approved by the manufacturer, or the installation or use of non-genuine parts, accessories, equipment, assemblies or components.

by **sarbarooliberty** » Mon Feb 09, 2009 3:37 pm

Thanks for the info...

so in other words if I want to keep the warranty and not have any issues with it i dont touch the car till the warranty is out.

Thanks again

Apexi intake manual

Apexi intake manual

Who is online