Page 1 of 1

Connector Clip loose under TMIC?

PostPosted: Tue Nov 03, 2015 2:27 pm
by tom_kauf
I noticed this loose black wiring clip under the TMIC. Does anyone know where it's supposed to go? I had a look but couldn't see.

Doesn't have much play/movement in the cable, so it can't go far.

From a distance :
Image

Closer:
Image

Closest:
Image

Re: Connector Clip loose under TMIC?

PostPosted: Tue Nov 03, 2015 2:45 pm
by BillyCorgi
Just a guess.

My 6MT has a similar wire harness standoff clip about 40mm from the centre of the rear bolt for the pitch stopper
look here
http://imgur.com/KtZLYmd
Check it out??

Re: Connector Clip loose under TMIC?

PostPosted: Tue Nov 03, 2015 4:02 pm
by tom_kauf
BillyCorgi wrote:Just a guess.

My 6MT has a similar wire harness standoff clip about 40mm from the centre of the rear bolt for the pitch stopper
look here
http://imgur.com/KtZLYmd
Check it out??

Cool, thanks Peter - will doing shortly when I'm home from work.

Re: Connector Clip loose under TMIC?

PostPosted: Thu Nov 05, 2015 11:41 am
by tom_kauf
Thanks Peter, it went here :) :

Image

Re: Connector Clip loose under TMIC?

PostPosted: Thu Nov 05, 2015 11:43 am
by BillyCorgi
I saw that available hole on my car, however the 3.0R did not have anything stuffed in that hole.
It was in the other hole indicated.
Good to see you found its home!

Re: Connector Clip loose under TMIC?

PostPosted: Thu Nov 05, 2015 12:46 pm
by tom_kauf
BillyCorgi wrote:I saw that available hole on my car, however the 3.0R did not have anything stuffed in that hole.
It was in the other hole indicated.
Good to see you found its home!

Ah ok. I already had something in the other hole. But good to know.