club.liberty.asn.au

Hey guys,

I know chances are pretty slim, but is there a FMIC out there that would fit a Post FL Gen IV without the need for reo removal and bumper cutting?

Thinking of putting my 20G in the Liberty along with the usual supporting mods

Regards,
Daz

The cx racing kit 'fits' with the reo still in tact however I think a little of the bumper needs to be trimmed and the pipework will need fabbing to work properly.
A lot of the guys in the states are waiting for the grimspeed FMIC I think.

Hmmm... Might wait around to see what Grimmspeed releases. Cheers mate!

I did the CX racing kit.
no reo removal, and only required me to buy 2 extra silicone bends, and shaving the inside of the front bar.
For the price, you cant lose.

imania wrote:The cx racing kit 'fits' with the reo still in tact however I think a little of the bumper needs to be trimmed and the pipework will need fabbing to work properly.
A lot of the guys in the states are waiting for the grimspeed FMIC I think.

You mean TMIC?

Sean82 wrote:

imania wrote:The cx racing kit 'fits' with the reo still in tact however I think a little of the bumper needs to be trimmed and the pipework will need fabbing to work properly.
A lot of the guys in the states are waiting for the grimspeed FMIC I think.

You mean TMIC?

Perhaps, has been a while since I read anything about it.

Where to buy this cx racing kit locally?

Fmic mate

dja wrote:Fmic mate

Grimmspeed aren't developing a fmic Dan; only tmic, hence my query

dazzz168 wrote:Where to buy this cx racing kit locally?

Nobody sells localy, I imported mine as have a few people

holy cow these are cheap! any downfalls?

Yes downfall is that the pipes off the cooler dont fit. Need to be refabbed and chop the front bar up. I managed to fit one to mine but the fog covers dont fit in properly.