club.liberty.asn.au

I bought this resin intake manifold via this forum.
Just wondering about its origin.

Resin mani: the port at the front of it turns left, another one that I have turns right. It did contain the same PVC type that is found on a postFL GT B.



Harness: presumably from an engine w/ dual AVCS heads given the amount of plugs near the injector plugs?



Stock side feed fuel rails: these were connected to:


TGV-less side feed injector risers: not TGV deletes, so presumably JDM?



DBW Throttle Body. (See above)

Rough guess: JDM preFL GT?

That's pre-FL GT mate, JDM maybe, but definitely the ADM one.

Those TGV's are from a JDM post fl.

I bought a set thinking that they would bolt straight on as it was from a JDM version on my car and NO DICE. Wrong height, wrong inj location, wrong fuel line mount locations..... So i ported my original TGV's.

So i would say a JDM Spec B Post FL

Boostaddict wrote:Those TGV's are from a JDM post fl.

I bought a set thinking that they would bolt straight on as it was from a JDM version on my car and NO DICE. Wrong height, wrong inj location, wrong fuel line mount locations..... So i ported my original TGV's.

So i would say a JDM Spec B Post FL

Resurrecting thread here - that would mean JDM post-fl was still side feed? seems odd, but plausible.

I'm fairly sure these are simply adm prefl liberty gt 2.0t.