club.liberty.asn.au

As title says... i know it should go in exhaust section but i have a followup question so bare with me...

as i am unable to find or get a phat dump pipe (unless someone has one for me... in auto for our 2.5) re there any that come close to this? and do you have links to purchase these... AVO, Xforce? invidia, cobb? and has anyone had good / bad experience with them...

also... is this the right fit for our model?

http://www.amazon.com/Perrin-PSP-ENG-32 ... +legacy+gt

thanks guys..

Hit up TCPAUTO in the vendor section for a dump pipe... tbear might have some new stock

Yes, looks to be the correct intercooler for the 2.5T...depends if the USDM Legacy GT has the same flanged turbo like ours..

i had hoped it would be the same cooler... since i dont think perrin make a seperate model listing for our cars or usdm cars on the site...

but wouldnt be the first time i was wrong about something!

does anyone know if the process west cooler is able to retain the engine cover?

frankos39 wrote:does anyone know if the process west cooler is able to retain the engine cover?

Just the front half of the engine cover

ahhh ok... good cooler but want to keep as mcu stock look as possible.
stick with the perrin then.