club.liberty.asn.au

Gday all,

I was wondering if anyone had the Hyperflow TMIC and the "flexible strut bar"? I'm sure through my days of searching around here that that combination exists.

Just a question on whether they fit together without fouling issues?

Also - how much trimming of the engine cover?

If you could provide an engine bay photo of the two together I'd appreciate it.

Thanks in advance.

Andrew

Found this photo, shows the Hyperflow TMIC(albeit a black one) fitted to the MY07... and plenty of room for the strut brace...

Should have just put the strut brace over the top last night when I tried to fit it...

GTB Liberty wrote:Gday all,

I was wondering if anyone had the Hyperflow TMIC and the "flexible strut bar"? I'm sure through my days of searching around here that that combination exists.

Just a question on whether they fit together without fouling issues?

Also - how much trimming of the engine cover?

If you could provide an engine bay photo of the two together I'd appreciate it.

Thanks in advance.

Andrew

Andrew.........


they will both fit together no worries

usual triming of the engine cover will be required to fit the hyper flow cooler

Jimmy my bar is the "flexible" circular one ...



It sits very differently to the flatter "older" bar design.

PS - Oh thanks Michael. Always a wealth of info.

SOLD Jimmy.

Good shizz...