Page 1 of 1

New stainless Cat back exhaust

PostPosted: Sat Apr 10, 2010 2:07 pm
by ItstheLPC
Ive just replaced the stock muffler system cat back and It sounds pretty good, tig welded 3' to 2.25's on the y and new hi flow mufflers. Although I feel like ive lost some low down torque ? is this common?

Re: New stainless Cat back exhaust

PostPosted: Sun Apr 11, 2010 8:06 am
by cruisn
Yes this is normal as youve lost some backpressure with the freer flowing system. You should have a little more top end now though. Thats the trade off.

Re: New stainless Cat back exhaust

PostPosted: Sun Apr 11, 2010 4:17 pm
by ItstheLPC
Cheers,
I reset the ECU and most of the torque seems to have come back. Perhaps the oxygen sensor played a part?
Not sure, but all is swell. Really enjoying the nice note, sure it doesn't rumble but it does pur.

Re: New stainless Cat back exhaust

PostPosted: Sun Apr 11, 2010 4:49 pm
by tangcla
ItstheLPC wrote:Really enjoying the nice note, sure it doesn't rumble but it does pur.

I actually like the flat note of the 2.0T. No rumble, but if you want rumble then go buy a WRX.

Sort of sounds like a four-cylinder version of a Ferrari 360... very raspy, especially when cold.

Re: New stainless Cat back exhaust

PostPosted: Sun Apr 11, 2010 5:41 pm
by Arith
tangcla wrote:if you want rumble then go buy a WRX.

Or upgrade to a MY07 onwards. :D

Re: New stainless Cat back exhaust

PostPosted: Sun Apr 11, 2010 6:40 pm
by tangcla
Arith wrote:
tangcla wrote:if you want rumble then go buy a WRX.

Or upgrade to a MY07 onwards. :D

Refer previous post. :P

Re: New stainless Cat back exhaust

PostPosted: Thu Apr 15, 2010 5:38 pm
by cruisn
I prefer the rumble.

Luckily Ive got my Legacy for that. :D