I am from the states and imported a 2008 Spec-B front clip from Hong Kong. Everything is together, but since my setup is a bit of a Frankenstein (2005 USDM Outback XT, 2005 EJ20X ECU, 2008 EJ20Y with a VF45) I need to check the wiring for the cam sensors. My tuner mentioned that Subaru switched from a 2-prong sensor to 3-prong after the facelift, so now I have to square away the wiring; I got it running but threw p0365 and p0390 codes, and with some digging I noticed that the wiring to the 135 ECU plug wasn't finished (I need connections to pins 28-30).
Does anyone have a service manual for a revised 4th-gen Legacy (2006-08, BL) that shows wiring and pin locations? Every single manual I've found has the earlier setup, I've used the half-dozen normal Subaru manual websites and not one shows the correct late EJ20X/Y setup. Here is my specific wiring setup so far: http://www.subaruoutback.org/forums/109 ... ost4968361 and this is my swap thread: http://www.subaruoutback.org/forums/109 ... t-ons.html
I'm happy to swap to an earlier sensor, I've already cleaned the sensors with MAF spray, and would love any sources or advice. Thanks all!