club.liberty.asn.au

Hi guys,
I just purchased a HKS boost controller from phat, hope to install it very very soon. does anyone know what the standard boost is for the my06 gt sti is?
and how much are they capable of running with the standard turbo?

i really dont want to do any damage or spend too much more.

thanks
norm

Norm speak to XRC15T as Franky is a MY06GT STi running sum more boost with the HKS.

Phil.

MY07GT wrote:Norm speak to XRC15T as Franky is a MY06GT STi running sum more boost with the HKS.

Phil.

thanks for that phil

from memory I believe around 14 psi is standard. Are you going to use the boost controller in tandem with tune? Just increasing boost without anything is not a great idea in my book and good way to go ping boom bang with engine!

I think the stock GT runs 0.7 bar (about 10psi), and since it's not a huge power increase, I'd say something similar.

GTSPECB STI wrote:from memory I believe around 14 psi is standard. Are you going to use the boost controller in tandem with tune? Just increasing boost without anything is not a great idea in my book and good way to go ping boom bang with engine!

I know of about 6 GTs with no tune but basic mods running perfectly fine. As long as you dont go crazy there shouldnt be a problem.

Phil.

GTSPECB STI wrote:from memory I believe around 14 psi is standard. Are you going to use the boost controller in tandem with tune? Just increasing boost without anything is not a great idea in my book and good way to go ping boom bang with engine!

there is a place in rockdale that has been recomended to me to do the tune.ill get the tune done before i use it.
has anyone used this place before and have any feedback?

is it autotech in rockdale?

Stock 13.5 psi.

I'm running 1 bar low, 1.2 bar high.
I have been upto 1.26 but i wound it back.

Disclaimer clause:
The abovementioned statistics is subject to variable conditions*. Therefore these statistics do not apply to all circumstances and may lead to Kaboooooooooom. In the case that this event happens XRC15T will not take any responsibilty.

*Conditions such as, but not limited to climate, fuel, supporting modifications etc etc.

1 bar = 14.503 773 801 pound/square inch

Mr Information you can always depend on Franky for the low down techie stuff.

Do you know what PSI for a normal GT?

I'd say it would be hte same psi for gt..