Logging with Tactrix Openport 2.0 Cable

[I Wish]

To those with this cable and have been using it to log directly to the SD card.

Can someone possible edit the logcfg.txt file to log the following parameters?

A/F Sensor #1 (AFR)
A/F Sensor #2 (AFR)
Engine Load (Calculated) (g/rev)
Engine Speed (rpm)
Feedback Knock Correction (1-byte)** (degrees)
Fine Learning Knock Correction (1-byte)** (degrees)
IAM (1-byte)** (multiplier)
Ignition Base Timing* (degrees)
Intake Air Temperature (C)
Intake VVT Advance Angle Left (degrees)
Intake VVT Advance Angle Right (degrees)
Knock Correction Advance (IAM only)* (degrees)
Mass Airflow (g/s)
Throttle Opening Angle (%)
Vehicle Speed (kph)

I have found the parameters in the logger definitions from Romraider. But the some of the fields are too technical for me.

[Spec B Wgn]

What i would so is send a friendly email or message to Edward.

These are his forum topics and hes a nice guy with a wealth of tuning knowledge

viewtopic.php?f=16&t=7207&start=165

Ive learnt heaps from him and he open to helping others

let us know how you go

Q

[I Wish]

I have asked him. He doesn't know too much about the new Openport 2.0.