club.liberty.asn.au

Posted: **Tue Jul 05, 2016 3:40 am**

Hey you all,

the centre diff of my 2005 legacy 3.0 spec B had to be replaced,
but now i am looking for some help in reassembly, because there are 2 washers where I am not sure where they belong to.

As you can see in the Pic there is a washer placed in the housing. I think it belongs there. But I have a second washer, where does it belong ? Help please

Greetings,
Julian

Posted: **Tue Jul 05, 2016 8:05 am**

Both washers go on the transfer drive gear.

Did you replace the bearings aswell?

Posted: **Tue Jul 05, 2016 9:08 am**

subarujulian wrote:Hey you all,

the centre diff of my 2005 legacy 3.0 spec B had to be replaced,
but now i am looking for some help in reassembly, because there are 2 washers where I am not sure where they belong to.

As you can see in the Pic there is a washer placed in the housing. I think it belongs there. But I have a second washer, where does it belong ? Help please

Greetings,
Julian

The transfer gear thrust washer selection is covered in pages 6MT-48 & 6NT-49 of the 6MT section of the Legacy Factory Service Manual.
If you have replaced your differential, then these sizes need to be checked to select the correct thickness thrust washer to suit the replacement differential.

Posted: **Tue Jul 05, 2016 4:49 pm**

cliffo3rb wrote:Both washers go on the transfer drive gear.

Did you replace the bearings aswell?

So the second washer goes stacked on the first one shown in the pic ?

I did not replace the bearings :oops:

Posted: **Tue Jul 05, 2016 5:03 pm**

BillyCorgi wrote:
The transfer gear thrust washer selection is covered in pages 6MT-48 & 6NT-49 of the 6MT section of the Legacy Factory Service Manual.
If you have replaced your differential, then these sizes need to be checked to select the correct thickness thrust washer to suit the replacement differential.

Thank you Peter, but will it be always exact 2 washers with different thicknesses or sometimes only one, or maybe three ?

When I removed the extension case with transmission still in the car, one washer just fell out. I am afraid it doesn't belong on the transfer drive gear but I coulnd't find any other position where it could have fitted.

Thank you both so much !

Posted: **Tue Jul 05, 2016 5:47 pm**

Here is the list of the standard thrust washers available
The OD and ID are listed for confirmation?

forum image hosting

What are the thickness(es) of washers you have?

You may need to do the thrust washer selection process to confirm the washers that you have a re correct for the housing?

club.liberty.asn.au

Need help Centre Diff Assembly

Need help Centre Diff Assembly

Re: Need help Centre Diff Assembly

Re: Need help Centre Diff Assembly

Re: Need help Centre Diff Assembly

Re: Need help Centre Diff Assembly

Re: Need help Centre Diff Assembly