club.liberty.asn.au

Cause mine turned into a bum.
It had a big crack down the middle. With a hole in it. And it gave me the shits..
When I rang SunSpares and asked about a plenum for a H6 he said "Lemme guess, yours has split down the middle??" ...So it's obviously not uncommon.
A used one from the wreckers would only give me more grief, so I sent it off to the plastic welders, and for only $44, he gave it a butt plug..
Is it wrong that I sent the wife to pick it up??

I noticed what looked like the start of a crack in mine. Time to see if i can do some patching up.
Thanks for the heads up.

Top or bottom side?

Top Dan, just above throttle body inlet.

Sweet. I know its not hard to take it off but is always easier if it on the top. Ill have a sticky beak later on. Cheers for the heads up

Just checked mine and it's cracked =O
Never really noticed since the cover is always on
Thanks for the tip dude (=

yep mines cracked too.

have any of you repaired this your self?

what product did you use?

now i need to go lift the friggin bonnet again.....

yep, cracked.
enough to see a torch-light through

I'll put some pressure on it and run a bead of Sikaflex in/ over it. that should fix it

Checked mine today as well and I have a hair line crack in it only a few millimeters long.
So tiny that hard to notice it. I think it's time to upgrade to something nice lol

Kakimoto.....

Yummy.
What are these worth and were from ?
I knew a member on here who had one. Should of jumped on it then.

For what seems like a pretty common problem would have thought more permanent fixes would be readily available. Id think of fixing it myself but the fear of any part of it flowing into the manifold wouldnt be very nice. For example if silicone was used my thoughts would be not too damaging but something like araldite or plastic weld etc could possibly do something harmful? Just me over stressing maybe?

What's the impact of this being busted?

Air fuel ratios being out as maf sensor is before the leak