club.liberty.asn.au

here is a kakimoto intake chamber going real cheap(well compared to retail) id buy if didnt have higher priorities right now
http://www.importmonster.com.au/view?url=http://page.auctions.yahoo.co.jp/jp/auction/101772074&thumb=http://f5.auctions.c.yimg.jp/img287.auctions.yahoo.co.jp/users/5/0/5/6/car_impact2006-thumb-119156947312230.jpg&title=3%200R%20BPE

unsure of power gains, if any but sure as hell looks sexy.

i want! shame i dont have the money... stupid flights costing so much

Be thankful you dont have the money, apart from bling I cant see at this time what it will do for the engine. The black plastic box will easily do as well and be far better at keep heat out of the airflow than the metal item which will be as hot as hell after a few minutes

Tradewind wrote:Be thankful you dont have the money, apart from bling I cant see at this time what it will do for the engine

its all about the bling it does look good, you gotta admit!

Tradewind wrote:The black plastic box will easily do as well and be far better at keep heat out of the airflow than the metal item which will be as hot as hell after a few minutes

which reminds me, i have to tape up my intake pipe! thanks tim

On my old car I used fibreglass matting on the underside of the water-to-air intercooler to keep the heat soak to a minimum. You could do that to the intake chamber if you wanted.