http://www.ebay.com.au/itm/06-07-Imprez ... e32654f&_uThis is the same lip i used, you will need to cut off the raised section at the front, i just took it slowly with a hacksaw, Line up the centre and fix into place with a self tapper. These a quite flexible, i then clamped it and worked my way from the centre out with more screws, the lip is about half a foot longer than needs be at either end, so when you get to each end turn your wheel away from the front bar as to allow the lip to be attached without hitting your tyre, now trim excess lip off and repeat at other side, i ended up using 15 self tapping screws, the purists on this site will diss the aplication method but hey you dont see the screws unless you have been run over by the car