The day goods arrived :)
Crap pads off the car:
Front - y u have no groove!?
Rear
Finished product (also added a instant 15kw at the brakes painting them red)
Zaccy182 wrote:The day goods arrived :)
Crap pads off the car:
jakey wrote:.... goshgollywingwong
Jack_Keaka wrote:the process of chris getting his parts as follows:
AB501UT!0N wrote:Zaccy182 wrote:The day goods arrived :)
Crap pads off the car:
Very nice mate and how are the Stop Tech pads?
Zaccy182 wrote:AB501UT!0N wrote:Zaccy182 wrote:The day goods arrived :)
Crap pads off the car:
Very nice mate and how are the Stop Tech pads?
Awesome so far mate. Gave them a bit of a work out before and they definitely have a nice bite on them even when cold. The last test will be lasting a week without colouring my wheels charcoal, gave them a nice clean today
jakey wrote:.... goshgollywingwong
Jack_Keaka wrote:the process of chris getting his parts as follows:
Zaccy182 wrote:Had a go at tinting the mars tail lights I got cheap off ebay. A couple of hours down and I finished one....
Not something I would recommend to everyone it is a pain in the butt to get right, I have this one almost perfect (sorry about the crap iphone quality) but there are a few air bubbles around and some small left over water bubbles which Im hoping will clear after a couple of days... I plan on doing the passenger side one tomorrow which Im hoping wont take as long and I decided on using the spray tint to do the blinker area... The film was cheap as off ebay and of pretty decent quality, took like 3 weeks to get here from china though .
before
After
jakey wrote:.... goshgollywingwong
Jack_Keaka wrote:the process of chris getting his parts as follows:
Zaccy182 wrote:Yeah a fair bit, you do need it or a heat gun for sure, it did the job though
jakey wrote:.... goshgollywingwong
Jack_Keaka wrote:the process of chris getting his parts as follows:
Zaccy182 wrote:I used a spray bottle with water and a small amount of soap and I sprayed both the tint and the surface so you can move it around/remove if you need to. You then heat it enough so it distorts and you move it around to get bubbles/creases out. I found using my fingers worked better then a card. Such a pain of a job
jakey wrote:.... goshgollywingwong
Jack_Keaka wrote:the process of chris getting his parts as follows:
AB501UT!0N wrote:Zaccy182 wrote:I used a spray bottle with water and a small amount of soap and I sprayed both the tint and the surface so you can move it around/remove if you need to. You then heat it enough so it distorts and you move it around to get bubbles/creases out. I found using my fingers worked better then a card. Such a pain of a job
It sure is a fiddly job to do and I am going to try and do it tonight or tomorrow night weather willing and I think I shall get a spray bottle and give that I shot!
Thanks again for all the info Zac
Users browsing this forum: No registered users and 30 guests