club.liberty.asn.au

ynot87 wrote:

Kekotic wrote:I like those better than the last rims. But I'm in to subtle rims so that's why.

What are the new rims? or keeping it secret?

secret haha all i will reveal is that they will be 18x9.5

Rota Grids! I knew it

Love the Advans though!

How long until the new shoes will be revealed?

Zerosports 350mm Steering with GDB WRX STi airbag cover retrofit.

OOohhh Tony!!

Did you buy the wheel from Pin???? Omg... I sooooo wanted it, but car service deemed more important! But man it looks so good!! Guess i will just have to look at this photo and think of what could've been on my car! hahaha!

d-chang wrote:OOohhh Tony!!

Did you buy the wheel from Pin???? Omg... I sooooo wanted it, but car service deemed more important! But man it looks so good!! Guess i will just have to look at this photo and think of what could've been on my car! hahaha!

Yeah I got it from Pin, really nice guy!
You should have bit the bullet when you had the chance haha. looks and feels so good.

Glad to see it found a good home

Photo dump of my new setup:
Enkei NT03+M SBC Finish 18x9.5 +40 (3mm spacers in the rear)
Nitto NT05 225/40/18
-2 degrees camber all round

That is a BOSS setup!

How much spacer would be required to run Brembros at the front?

You know I love a motorsport spec rim with that next level finish

That looks amazing Tony. Friggin sexual. Well done

Thanks guys.

bigBADbenny wrote:That is a BOSS setup!

How much spacer would be required to run Brembros at the front?

You know I love a motorsport spec rim with that next level finish

Ben these wheels need 10mm spacers to clear brembos.

Love it! Did you have to raise the height of your vehicle with that flush/poke fitment? I've got the rear at -22.5 mm and I'm running 17x8 +52 mm 2011 WRX rims with 235/45R17 tyres.

cooki_monsta wrote:Love it! Did you have to raise the height of your vehicle with that flush/poke fitment? I've got the rear at -22.5 mm and I'm running 17x8 +52 mm 2011 WRX rims with 235/45R17 tyres.

Thanks mate,
not sure what you mean by -22.5mm. but what you see in the pics is the height that I run as a daily. tyres tuck around 8-10mm all round

sick fitment. looks so good! do you scrub in that edge where the front bar connects to the quarter panel?

renan_don18 wrote:sick fitment. looks so good! do you scrub in that edge where the front bar connects to the quarter panel?

thanks. yes it did but i've cut that out and made a new mount further back so it doesn't hit anymore

awesome. I'll need to do the same thing. thanks

ynot87 wrote:Zerosports 350mm Steering with GDB WRX STi airbag cover retrofit.

ooooh, have just seen this, now I wish I'd ordered my DAMD wheel with red stitching
Oh well.

Was it much of an effort to retrofit the STi airbag cover? There is one for sale on OzFoz, but it only has one electronic connector on it so far as I can tell, but I know our cars have two (the orange clip and the yellow). Very keen to steal your idea

And as I said on the FB page, mate, the rims look fantastic!