Numberplate spacer/lift kit

[cruisn]

Ive made the number plate spacer/lift kit. Its raised 50mm from standard and sits out of the lower air dam now.

Made from black nylon and machined to clear the ridge above the number plate stock location. It sits 10mm further out from the original mounting points. Countersunk lower mounting holes and new drilled and tapped number plate mounting holes.

If people are keen, I can make some more. It will come with stainless steel allen key bolts and is a direct swap. Price will be $25 posted.

I will have to confirm the mounting height required for different model bars just to be sure theyre the same.

Before....



After...

[imania]

Really nice work, any chance we can have a look at the part itself? Don't stress if it means removing your plate

[Kekotic]

Am I reading this wrong? You have to drill new holes in the number plate?

[Robbks]

Mark, one for me

been looking at doing this myself, but just another CBF'd little mod i haven't gotten around to

hit me with bank details and i'll shoot you cash
I can get measurements for pre-facelift 3RB for you

cheers

[cruisn]

Am I reading this wrong? You have to drill new holes in the number plate?

Does it look like theres new holes in the numberplate when its lifted?

Utilises all original mounting points.

Mark, one for me

been looking at doing this myself, but just another CBF'd little mod i haven't gotten around to

hit me with bank details and i'll shoot you cash
I can get measurements for pre-facelift 3RB for you

cheers

Measurements would be appreciated Rob. From centre of the numberplate mounting hole in the bumper to the ridge above and if you ould check if 50mm lift is right to clear your lower air dam.

After i make them I'll get back to you with details.

Cheers

[cruisn]

Really nice work, any chance we can have a look at the part itself? Don't stress if it means removing your plate

Will get a pic of it in detail tomorrow for all to see. I made mine in white nylon, but it gets dirty. Black is better IMO.

[seanmau5]

I'm getting in on that!!! Shoot me a pm with deposit details, transfer or Paypal is good for me. Need pre facelift 2.5i measurements?

[cruisn]

I'm getting in on that!!! Shoot me a pm with deposit details, transfer or Paypal is good for me. Need pre facelift 2.5i measurements?

No worries. Measurements would be good thanks.

[seanmau5]

Will post them up tomorrow

[teK--]

Need one that is spring loaded and flips inside the bumper at speed

[Ben]

Nice one Mark, looks the goods!

[cruisn]

Pics as requested. It moves the numberplate 10mm out from the bar and doesnt look out of place.

[Gambit]

Nice work there , I had to drill my plates rather than offset, your is a much neater install

[cruisn]

Nice work there , I had to drill my plates rather than offset, your is a much neater install

Cheers.

The aim is to modify for a better result without cutting or drilling anything that doesnt need to be.

[cruisn]

Update......

I have just aquired some alloy so these will be made out of alloy now.

Ready in 2 weeks.