club.liberty.asn.au

Sooooo just broke another 5eat auto.

jslayz wrote:Sooooo just broke another 5eat auto.

6mt time?

I'm thinking so, I already have one ready.....just need a good clutch and then install it and the matching diff.
Will need a manual ROM from matt too.

jslayz wrote:Sooooo just broke another 5eat auto.

What the fuck J....

What's the diagnosis?

too much clutch....lunched internals after 1st to 2nd change

I should quantify, I've been running AB08rs as peeps will know and its been chirping those on gear changes in the dry

Knew it was going to happen sometime, just not when.

Collect it tomorrow as had axle seals that needed replacing crop up when filling the 6MT.

Just running HD Exedy clutch and standard machined flywheel.

If if test drives ok tomorrow I can collect it.

Just a bit excited....

jslayz wrote:Collect it tomorrow as had axle seals that needed replacing crop up when filling the 6MT.

Just running HD Exedy clutch and standard machined flywheel.

If if test drives ok tomorrow I can collect it.

Just a bit excited....

That was super fast

Do you have pics of the modified / custom trans xmember ?

Not yet Mick. Maybe later today

Looks factory

Dang about the lunched 5eat.

But that 6spd x-member is a sexy AF bit of kit.
Can't wait to see the next evolution J!

Thanks Troy,
unfortunately it is in limp mode 20% throttle and no boost.
Still fast enough to get around though.
Sooooo much quieter at cruise and no drone, loving my exhaust a lot more now.

Matt where are you??

jslayz wrote:Matt where are you??

In sydney giving Owen reach-arounds according to failbook.

You may have already mentioned this, but what shop did the 6mt conversion?

ASG All Star Garage